Can You Put a Metal Roof Over Shingles?
Installing metal over an existing shingle roof skips the tear-off, so it's tempting. Sometimes the code allows it and it works. Often a tear-off is the better roof. Here's what the residential code says, what goes wrong, and how we decide.
Open 24/7 · 2204 W Anderson Ln, Austin, TX 78757
The Short Answer
- The residential code allows a recover over existing roofing in some cases, if the manufacturer's instructions allow it.
- A recover is not allowed when the roof already has two or more layers.
- It's also not allowed over a water-soaked or deteriorated roof, or over slate, clay or cement tile.
- Skipping tear-off hides the deck, so rot and soft spots go unrepaired under a roof meant to last decades.
- Your local building department and the panel manufacturer have the final say.
When a recover isn't allowed
| Situation | Recover allowed? |
|---|---|
| One existing layer of asphalt shingles, sound deck, manufacturer allows it | Possibly, subject to local code and permit |
| Two or more existing layers | No |
| Existing roof water-soaked or deteriorated | No |
| Existing slate, clay, cement or asbestos-cement tile | No |
| Existing wood shakes | Metal is allowed with additional requirements |
Based on the International Residential Code reroofing section (R908 in recent editions). Austin's adopted edition and amendments, and your panel manufacturer's instructions, govern your project. This is not code or legal advice.
Why we usually recommend tear-off
You can't see the deck
Tear-off is the only way to find and replace soft or rotted decking. Under a recover, it stays hidden.
Fastening is harder
Fasteners must go through the old shingles and still hold in the deck. Old, uneven shingles make that less consistent.
Uneven surfaces show
Ridges and humps in old shingles can telegraph through flat metal panels and add to oil canning.
Flashing gets compromised
Wall, chimney and valley flashing works best rebuilt from the deck up, not layered over old details.
Added weight
A recover adds load on top of the existing roof. Metal is light, but it's still more weight.
Moisture and heat
Old shingles under metal can trap moisture and change how the attic ventilates if the details aren't right.
How we decide
On a single layer of flat, sound shingles over a solid deck, with a panel system whose manufacturer allows it and a building department that will permit it, a recover can work, especially on outbuildings and some exposed fastener roofs. Some installers also run purlins or battens over the old roof to create a new, flat nailing surface. We'll check the layer count, walk the deck for soft spots, look in the attic, and tell you which approach makes sense, in writing.
For most homes, we recommend metal roof replacement with a full tear-off: the deck gets inspected and repaired, and the new roof starts flat. See metal roof vs. shingles if you're still deciding on metal, oil canning on metal roofs for why a flat surface matters, and the metal roof cost guide for how tear-off affects price. For residential metal roofing, the conversion process is laid out step by step.
We get asked this on most shingle-to-metal estimates for metal roofing in Austin. If one Austin metal roofing bid is much lower than the rest, check whether it skips the tear-off. Every quote for a metal roof in Austin should say so plainly, and our metal roofing in Austin, TX estimates always do.
More from Austin Metal Roofing Pros
Wildfire-resistant metal roofs
Class A metal roof assemblies for homes in Austin's WUI areas.
Wildfire-resistant metal roofs in AustinEmergency metal roof repair
Open 24/7 for storm damage, lifted panels and active leaks.
Emergency metal roof repair in Austin24 vs. 26 gauge
How steel thickness changes hail, dent and waviness resistance.
24 vs. 26 gauge metal roofingStone-coated steel
Shake, tile and shingle looks with a Class 4 impact rating.
Stone-coated steel roofing in AustinPatio covers and porch roofs
Low-slope tie-ins, flashing to the house, and matching finishes.
Metal patio covers in AustinBrowse all Austin metal roofing services, compare metal roof systems in Austin, or read more Austin metal roofing guides.
Frequently asked questions
Can you put a metal roof over shingles in Austin?
Sometimes. The residential code allows a recover over one existing layer in some situations if the manufacturer allows it, but not over two or more layers or a deteriorated roof. Your permit and the manufacturer's instructions decide.
Is it cheaper to put metal over shingles?
It skips tear-off and disposal, so the upfront cost is usually lower. The trade-off is that the deck goes uninspected under a roof meant to last decades.
How many layers of roofing are allowed?
Under the residential code, a recover isn't allowed when the roof already has two or more layers of any roof covering.
Do I need a permit to put metal over shingles?
Many jurisdictions require a permit for reroofing. Check with your city's building department before the work starts.
Tear-Off or Recover?
Call (512) 501-4970, open 24/7, or request an estimate. We'll check layers, deck and attic and recommend in writing.
Austin Metal Roofing Pros · 2204 W Anderson Ln, Austin, TX 78757 · Open 24/7